FOnline Development > 3D Development
3d models development
Surf:
--- Quote from: bikkebakke on February 08, 2011, 10:37:40 pm ---BLASPHEMY!
FoT armors me gusta >_>
--- End quote ---
They aren't the FO1/2 styles retrofuturistic shaped armors, they look too generic and "badass". That's why it won't really fit. ;)
Karpov:
I don't like the power armor, the metal and much less the leather armor from Tactics, but I think the environmental armor was really nice.
Ok, I made some new anims: knife thurst, throw, and sledgehammer holster and swing. Last one goes for the author of the hammer , TheBob/ahBobSaget/Gorlak I don't know how to call him.
Also a new hairstyle, not very polygon efficient though :). Hope you like it.
http://www.youtube.com/watch?v=QEWZtrijUbs
Bye.
Surf:
It looks really good Karpov! Gotta say I was more then skeptical at this 3d stuff, especially because these Van Buren Models/Stances look just so bad. But you managed to almost mimicry the original ones, that's good! Personally, I would love to see some sort of dithering filter layed over the 3d models so they look a bit better compared and well fit in to the rest of the enviroment, but thats maybe just me. :)
Lexx:
--- Quote from: Karpov on February 08, 2011, 11:10:54 pm ---but I think the environmental armor was really nice.
--- End quote ---
Yes it was and I doubt someone would go rampage, if we get a similar armor into FOnline.
Alvarez:
What's exactly bad on the Midwestern PA, except for badassery and generic look?
Maybe because they look too much like Predators and not knights?
Edit: Wait, shit, i know: they look exactly like Enclave Advanced PAs from the Spawn Of Beth. Midwestern PAs must be their direct predecessors.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version